![]() ![]() ![]() Three IP addresses are returned, in this case there is one IP address each for Mgmt, VMotion and NFS traffic. Uemcli -d 10.0.0.1 -u Local/admin -p Password123# /remote/host show It takes approximately ~2 minutes to add each host after receiving the output above. It will continue to add or update ESX host information in the background. The create, refresh, or set operation has started. Operation completed with partial success. Uemcli -d 10.0.0.1 -u Local/admin -p Password123# /virt/vmw/esx create -addr 192.168.105.11 -username root -passwd Password Uemcli -d 10.0.0.1 -u Local/admin -p Password123# /virt/vmw/esx create -addr 192.168.105.10 -username root -passwd Password Using the ESXi mgmt address to add two ESXi hosts as follows: Note: VMWare networking and Nexus port channels must be configured at this stage. Add VNXe NFS Volumes to VMware ESXi Hosts.Here I will detail the Steps involved in adding VMware ESXi hosts, presenting NFS datastores to these hosts and setting access rights. This is the third part in the series on configuring the VNXe via command line. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |